How to Mix Peptides
Step-by-step guide for reconstituting your research peptides with bacteriostatic water for injectable use.
Important Notice
For research purposes only. Not for human consumption.
These instructions are provided for laboratory research and scientific investigation. Always follow proper laboratory protocols and safety procedures.
Reconstitution Instructions (Injectable)
Remove the Cap
Gently pull off the cap from the peptide vial. Handle the vial carefully to avoid contamination.
Sanitize the Vials
Use the alcohol wipes (included in your kit) to thoroughly clean the tops of both the peptide vial and the bacteriostatic water vial. This ensures sterile conditions.
Draw the Water
Take your syringe, insert the needle into the bacteriostatic water vial, and draw out your desired amount of water for reconstitution.
Tip: The amount of water you use will determine your final concentration. Use our dosage calculator to find the ideal ratio for your research needs.
Inject the Water
Slowly inject the water into the peptide vial by pushing the needle through the center of the rubber stopper.
Guide: Use the raised circle on the stopper as your guide. If you encounter resistance, try positioning the needle slightly off-center.
Control the Flow
Aim to let the water slide down the side of the vial rather than splash directly onto the powder. This gentle approach helps preserve the peptide integrity.
Caution: Never let the water jet directly onto the powder as this can damage the peptide structure.
Dissolve Gently
Gently roll the vial between your fingers to dissolve the contents. The powder should gradually dissolve into a clear solution.
Never shake the vial! Shaking can denature the peptides and reduce their effectiveness.
Store Properly
Once fully mixed, store the vial upright in your refrigerator until use. Keep away from direct light.
What's Included in Your Kit
Every vial is a complete kit containing:
Peptide Vial
Lyophilized (freeze-dried) powder in sterile vial
Bacteriostatic Water (3ml)
Sterile water for reconstitution
Alcohol Wipes
For sanitizing vial tops
1ml Insulin Needles
For drawing and injecting water
Critical Safety Notice
NEVER re-use a needle. Each needle should only be used once and then disposed of safely in a sharps container.
NEVER share needles. Sharing needles can transmit serious infections and is extremely dangerous.
Always use a fresh, sterile needle for each use to maintain sterility and prevent contamination.
Pro Tips for Best Results
Allow the water to reach room temperature before mixing for faster dissolution.
If the powder doesn't dissolve immediately, be patient. Continue rolling gently until fully dissolved.
Always check the solution is clear before use. Any cloudiness may indicate improper mixing.
Label your vial with the date of reconstitution to track freshness.
Use our dosage calculator to determine the correct injection volume for your research protocol.
For research purposes only. Not for human consumption.
These instructions are for injectable peptide reconstitution only. Not applicable for nasal spray formulations.